|
Mark VII CombiWash configuration
Use Activa Direct Arming for the Mark VII CombiWash.
PLC Settings
Minimum firmware 3.28.
On the PLC:
- set module 60 (Entry System), parameter 13 to 002 - Wash in use - Extended - Unitec
- set module 70 (Special Function Menu), parameter 9 to 104 - Off when fault.
Activa Direct Settings
In Activa Direct:
- Set "Out-Of-Service when" to "Busy Signal Blink or Power Off"
- Set "Time to hold Arming Signal" to "15 minutes".
- Set "Time to wait for wash to begin" to "15 minutes"
Link:
|