Intelio Knowledge Base

This article has been saved to your Saved Articles List.

Available Categories

Other Options

Glossary

Index

General article information

Created	2008-11-20	Views	1707
Modified	2011-07-19	Id	67
Author	Adam Fanello

Main > WashMax > Teller Interfaces

	Print
	Save to list
	E-mail
	Subscribe

WashMax can work with the Unitec Wash Select II teller.
The Wash Select II and POS 4000 manuals are attached to the end of this article.

Hardware Interface

Configuration a Moxa:

For a Moxa nPort 5110, use a null-modem adapter.

Moxa settings:

TCP Server Mode
Serial port settings:

Baud: 9600 baud
Parity: None
Data Bit: 8
Stop Bit: 1
Flow Control: None
UART FIFO: Enabled

Set the IP address to something that works on the network. If connected into the Site Server's Auxiliary Connection #1, the teller's IP is typically 192.168.111.21. Set this same IP in EPG on the setting's Unitec tab.

Teller Configuration

Setup Generic Terminal Mode with extensions enabled.
Enable "Accept Proprietary".

Works best when washes are defined with the lowest end wash as wash type 1, with prices increasing with higher wash types.

Attachments

	POS_4000_v8.00_Manual.pdf - Size: 1634291
	WS21002_Operations_Manual_Rev_M_5-00.pdf - Size: 1999816
	MK7WT21003_4.71_Software_Upgrade_Instructions.pdf - Size: 1474795

AUTEC interface with WashMax
The WashMax site controller connects with an AUTEC car wash PLC via an adapter called a PPI MultiMaster. This adapter converts the RS-485 signals used by the car wash's...

Belanger interface with WashMax
Overview The Belanger Vector and FreeStyler car wash models offer limited capability to report faults to WashMax. Older WashMax site controller models may connect...

Istobal interface with WashMax
Overview The Istobal M series car wash models offer the capability to report faults to WashMax. Hardware connections Mount a serial device server, such as the Moxa...