Intelio Knowledge Base - Code-a-Wash Reports show incorrect change

Intelio Knowledge Base

This article has been saved to your Saved Articles List.

Available Categories

Other Options

Glossary

Index

Saved Articles

General article information

Created	2009-10-06	Views	1265
Modified	2010-01-06	Id	86
Author	Adam Fanello

Main > Site Server > Troubleshooting

	Print
	Save to list
	E-mail
	Subscribe

The Code-a-Wash application has settings indicating the monetary denomination of change given by the Activa. These values must match the Activa configuration, otherwise reports will be incorrect.

Login to the Code-a-Wash application.
Touch the Setup Menu button.
Touch the Coinbox button.
Touch the Currency tab.
Set Coin 1 Value to match the Coin Acceptor value on the Activa.
Set Change Value to match the Coin Dispenser value on the Activa.
If there is more than one Activa, touch the right arrow at the top of the screen to configure the next bay.

Use $1 Coins
To use $1 coins in the Activa coin dispenser, rather than quarters, you must change settings in two different places. On the Activa, Login to Maintenance mode....

How to configure a new Site Server (sserv) for latest
Assumptions The Site Server has been imaged by an Intelio sserv flash imager. (Don't forget the Post-Cloning script for an sserv7.) The Site Server is connected to an IP...

How to reprogram an Activa Bill Acceptor
This procedure describes how to reprogram an Activa bill acceptor. It assumes that the FP-001 Programmer device has already been loaded with the desired firmware program to...