|
|
Code-a-Wash Reports show incorrect change
|
The Code-a-Wash application has settings indicating the monetary denomination of change given by the Activa. These values must match the Activa configuration, otherwise reports will be incorrect.
Login to the Code-a-Wash...
Relevance: 56.26 | Site Server > Troubleshooting
|
|
|
Use $1 Coins
|
To use $1 coins in the Activa coin dispenser, rather than quarters, you must change settings in two different places. On the Activa,
Login to Maintenance mode.
Touch the System Setups button.
Touch the...
Relevance: 52.81 | Activa > Application Configuration
|
|
|
How to reprogram an Activa Bill Acceptor
|
This procedure describes how to reprogram an Activa bill acceptor. It assumes that the FP-001 Programmer device has already been loaded with the desired firmware program to install. Required parts:
An operational Activa with...
Relevance: 48.29 | Activa > Hardware Maintenance
|
|
|
Coin Dispenser Troubleshooting
|
Dip settings: All four dip switches on the bottom of the hopper should be set to “on”. This selects ICT protocol using the RS-232 interface.
The turret...
Relevance: 38.41 | Activa > Troubleshooting
|
|
|
Coin Acceptor Troubleshooting
|
For reference there are three coin acceptor switch settings:
The positions for each switch are identified on the moulded plastic housing.
Switch 1: set to MAX
Switch 2: set to NO
Switch...
Relevance: 35 | Activa > Troubleshooting
|
|
|
Activa Peripheral Device Documentation
|
This article is protected and thus no preview is available.
Relevance: 28.74 | Activa > Hardware Maintenance
|
|
|
How to configure a new Site Server (sserv) for latest
|
This article is protected and thus no preview is available.
Relevance: 24.78 | Site Server > Software Installation
|
|
|
How to configure a new Site Server (sserv) for Cobra
|
This article is protected and thus no preview is available.
Relevance: 22.69 | Site Server > Software Installation
|
