Intelio Knowledge Base

This article has been saved to your Saved Articles List.

Available Categories

Other Options

Glossary

Index

General article information

Created	2008-10-15	Views	1747
Modified	2009-11-05	Id	45
Author

Main > Activa > Troubleshooting

	Print
	Save to list
	E-mail
	Subscribe

For reference there are three coin acceptor switch settings:

The positions for each switch are identified on the moulded plastic housing.

Switch 1: set to MAX
Switch 2: set to NO
Switch 3: set to 25ms

Reject button can get stuck. Take button out and smooth edges of metal hole. Possibly bend top and bottom flanges around hole up to increase margins. Wd-40 has been used successfully.

It’s reported that tightening bezel of coin acceptor can cause errors. Apparently the metal plate can be warped and tightening it down makes it worse. Loosen the bezel to minimize distortion.

If the above does not correct the problem, file the inner opening edges of metal sleeve. Also, loosen the mounting screws of the Acceptor to a snug, but "Not" tight setting.

Attachments

coin-accepter-manual.jpg - Size: 162794

Coin Dispenser Troubleshooting
Dip settings: All four dip switches on the bottom of the hopper should be set to “on”. This selects ICT protocol using the RS-232...

CUSTOM TGO2 Printer
CUSTOM TGO2 Printer The TGO2 printer is 12 volts DC not 24 Volts DC. There is a crossover adapter sent with each printer. This goes on CON 10....

How to reset VNC password
If VNCing into a remote Windows computer fails due to bad authentication, then someone may have changed the password. Regaining remote access. (AKA, Hacking VNC) If...