Intelio Knowledge Base

This article has been saved to your Saved Articles List.

Available Categories

Other Options

Glossary

Index

General article information

Created	2008-11-20	Views	1493
Modified	2010-06-07	Id	70
Author	Adam Fanello

Main > WashMax > Carwash Interfaces

	Print
	Save to list
	E-mail
	Subscribe

Overview

The Belanger Vector and FreeStyler car wash models offer limited capability to report faults to WashMax.
Older WashMax site controller models may connect directly to a Belanger controller via an RS-232 cable. This is out of favor due to limitations however. The favored hardware configuration involves connecting a serial device server, such as a Moxa nPort, to the Belanger controller and to the site's Ethernet network or a Site Server's Auxiliary Connection #2.

Hardware connections

Mount the Moxa nPort near the Belanger controller and connect it to the site's Ethernet network. Use a standard serial cable to connect to Moxa to port ??? on the Belanger controller. Depending on the Belanger controller model, a null-modem adapter may be needed:

Model	Null-Modem Adapter with nPort DE-311	Null-Modem Adapter with nPort 5110
E-300	yes	no
E-410	yes	no
E-1063	no	yes

Serial Device Server configuration

When using a device server, it must be configured as:

Old scheme: 192.168.1.54 (Use 192.168.1.64 for a second bay.)
sserv Auxiliary Connection #2: 192.168.112.21
If this IP does not work for the site's network, any other address may be used but Intelio site controller must be configured with the alternative address.

Run as a TCP Server listening on port 4001
The inactivity timeout must be disabled .
Serial side set to 9600 baud, 8 bit data, 1 stop bit, no parity, and no flow control.

Edge Settings

The edge should find the Moxa if it's at one of the normal IP addresses for a Belanger Moxa. (As specified above.) If something else is used, you must edit /home/intelio/conf/site.properties and set belanger.ip.host to the IP address. The edge app must be restarted for it to take effect.

Attachments

FreeStyler_Fault_Codes.pdf - Size: 89492

Istobal interface with WashMax
Overview The Istobal M series car wash models offer the capability to report faults to WashMax. Hardware connections Mount a serial device server, such as the Moxa...

Allied ANDI
Source: Allied Electronics Online Documents Code-a-Wash Settings Setup Menu / Point of Sale: Ryko Protocol 9600 Baud Cable for most companies...

Allied NeXGen
Source: Allied Electronics Online Documents Code-a-Wash Settings Setup Menu / Point of Sale: Ryko Protocol 9600 Baud Cable NeXGen RJ45...