|
|
Bill Dispenser Maintenance
|
The Bill Dispensers must have routine maintenance to avoid continuous jams and to speed up the process of switching dispensers. The sensors, belts, and rollers get dirty fast and require cleaning at least once a month. Failure...
Relevance: 90.13 | Activa > Hardware Maintenance
|
|
|
Activa Peripheral Device Documentation
|
This article is protected and thus no preview is available.
Relevance: 88.82 | Activa > Hardware Maintenance
|
|
|
How to reprogram an Activa Bill Acceptor
|
This procedure describes how to reprogram an Activa bill acceptor. It assumes that the FP-001 Programmer device has already been loaded with the desired firmware program to install. Required parts:
An operational Activa with...
Relevance: 79.31 | Activa > Hardware Maintenance
|
|
|
Bill Acceptor troubleshooting
|
The Activa uses the A6 Series bill acceptor from International Currency Technologies (ICT). Documentation is attached. For dip switches under front panel of the acceptor must be set to ON OFF OFF OFF. Dip switches on the side of the...
Relevance: 53.81 | Activa > Troubleshooting
|
|
|
Use $1 Coins
|
To use $1 coins in the Activa coin dispenser, rather than quarters, you must change settings in two different places. On the Activa,
Login to Maintenance mode.
Touch the System Setups button.
Touch the...
Relevance: 44.61 | Activa > Application Configuration
|
|
|
Code-a-Wash Reports show incorrect change
|
The Code-a-Wash application has settings indicating the monetary denomination of change given by the Activa. These values must match the Activa configuration, otherwise reports will be incorrect.
Login to the Code-a-Wash...
Relevance: 28.07 | Site Server > Troubleshooting
|
|
|
Coin Dispenser Troubleshooting
|
Dip settings: All four dip switches on the bottom of the hopper should be set to “on”. This selects ICT protocol using the RS-232 interface.
The turret...
Relevance: 19.16 | Activa > Troubleshooting
|
|
|
How to configure a new Site Server (sserv) for latest
|
This article is protected and thus no preview is available.
Relevance: 7.36 | Site Server > Software Installation
|
|
|
How to configure a new Site Server (sserv) for Cobra
|
This article is protected and thus no preview is available.
Relevance: 6.73 | Site Server > Software Installation
|
