|
|
Belanger interface with WashMax
|
Overview
The Belanger Vector and FreeStyler car wash models offer limited capability to report faults to WashMax. Older WashMax site controller models may connect directly to a Belanger controller via an RS-232 cable. This is out of...
Relevance: 29.16 | WashMax > Carwash Interfaces
|
|
|
Approved Wire and Uses
|
Ethernet (Internet) Wire
Run one Ethernet cable from the network access point (modem, router, switch...etc) to each Activa Virtual Attendant and to the Activa Site Controller. Use shielded, Stranded CAT5e, any quality brand....
Relevance: 25.06 | Activa > Hardware Installation
|
|
|
Istobal interface with WashMax
|
This article is protected and thus no preview is available.
Relevance: 23.96 | WashMax > Carwash Interfaces
|
|
|
How to setup RykoNet over IP
|
This article is protected and thus no preview is available.
Relevance: 21.05 | Activa > Application Configuration
|
|
|
How to clear a stuck Belanger alert
|
This article is protected and thus no preview is available.
Relevance: 19.51 | Support
|
|
|
Activa Direct Wash Arming
|
Use Activa Direct arming to control the car wash through a direct wired connection to the Activa's I/O terminals.
To Select Activa Direct:
Log into the Activa using the technician login. (The owner...
Relevance: 16.12 | Activa > Application Configuration
|
|
|
Mark VII AquaJet and GT car wash configuration
|
Use Activa Direct Arming for the Mark VII car washes.
Activa Direct Settings
In Activa Direct:
Set "Out-Of-Service when" to "Controller Power Off"
Set "Time to hold Arming...
Relevance: 16.03 | Activa > Carwash Interfaces
|
|
|
Use $1 Coins
|
To use $1 coins in the Activa coin dispenser, rather than quarters, you must change settings in two different places. On the Activa,
Login to Maintenance mode.
Touch the System Setups button.
Touch the...
Relevance: 14.3 | Activa > Application Configuration
|
|
|
About Site Controllers
|
This article is protected and thus no preview is available.
Relevance: 13.94 | Site Server
|
|
|
AUTEC interface with WashMax
|
The WashMax site controller connects with an AUTEC car wash PLC via an adapter called a PPI MultiMaster. This adapter converts the RS-485 signals used by the car wash's PLCs to RS-232. The RS-232 end may be connected directly to an...
Relevance: 13.13 | WashMax > Carwash Interfaces
|
