Intelio Knowledge Base - Mark VII CombiWash configuration

Intelio Knowledge Base

This article has been saved to your Saved Articles List.

Available Categories

Other Options

Glossary

Index

Saved Articles

General article information

Created	2008-04-22	Views	2052
Modified	2008-04-30	Id	7
Author	Adam Fanello

Main > Activa > Carwash Interfaces

	Print
	Save to list
	E-mail
	Subscribe

Use Activa Direct Arming for the Mark VII CombiWash.

PLC Settings

Minimum firmware 3.28.

On the PLC:

set module 60 (Entry System), parameter 13 to 002 - Wash in use - Extended - Unitec
set module 70 (Special Function Menu), parameter 9 to 104 - Off when fault.

Activa Direct Settings

In Activa Direct:

Set "Out-Of-Service when" to "Busy Signal Blink or Power Off"
Set "Time to hold Arming Signal" to "15 minutes".
Set "Time to wait for wash to begin" to "15 minutes"

Mark VII AquaJet and GT car wash configuration
Use Activa Direct Arming for the Mark VII car washes. Activa Direct Settings In Activa Direct: Set "Out-Of-Service when" to...

How to reset VNC password
If VNCing into a remote Windows computer fails due to bad authentication, then someone may have changed the password. Regaining remote access. (AKA, Hacking VNC) If...

How to install SOC reporting on an Activa
This article provides the steps for performing the initial installation needed to add SOC reporting support to a teller (Activa), or to remove an old installation and...