Intelio Knowledge Base

Main > Activa > Carwash Interfaces  
Carwash Interfaces

Articles
Activa Direct Wash Arming
Use Activa Direct arming to control the car wash through a direct wired connection to the Activa's I/O terminals. To Select Activa Direct: Log into the A
- 2008-04-22 - Similar Articles

AUTEC car wash interface
Use Activa Direct Arming for AUTEC car washes. Activa Direct Settings In Activa Direct: Set "Out-Of-Service when" to "Busy Signal Blink or Power Off&qu
- 2009-04-27 - Similar Articles

Belanger Vector & FreeStyler car wash Interface
Use Activa Direct Arming for the Belanger Vector and FreeStyler car washes. Activa Direct Settings In Activa Direct: Set "Out-Of-Service when" to "Busy
- 2008-05-30 - Similar Articles

Futura Car Wash Interface
Use Activa Direct Arming for Futura car washes. Activa Direct Settings In Activa Direct: Set "Out-Of-Service when" to "Busy Signal Blink or Power Off&q
- 2008-06-09 - Similar Articles

Istobal car wash configuration
Use Activa Direct Arming for the Istobal car washes. Activa Direct Settings In Activa Direct: Set "Out-Of-Service when" to "Controller Power Off"
- 2009-11-19 - Similar Articles

Mark VII AquaJet and GT car wash configuration
Use Activa Direct Arming for the Mark VII car washes. Activa Direct Settings In Activa Direct: Set "Out-Of-Service when" to "Controller Power Off"
- 2008-04-30 - Similar Articles

Mark VII CombiWash configuration
Use Activa Direct Arming for the Mark VII CombiWash. PLC Settings Minimum firmware 3.28.On the PLC: set module 60 (Entry System), parameter 13 to 002 - Wash in use -
- 2008-04-30 - Similar Articles

Nu-Star car wash interface
Use Activa Direct Arming for Nu-Star car washes. Activa Direct Settings In Activa Direct: Set "Out-Of-Service when" to "Control Power Off" Se
- 2009-05-06 - Similar Articles

Powered by KnowledgeBuilder